Your VX360 device is set up, you’re ready to drive and start earning!
Before you hit the road and begin mapping, let’s make sure everything’s fully operational.
- Plug VX360 into your Tesla’s glovebox USB port
- Enable Bluetooth, GPS, and Internet on your phone.
- Enable Dashcam by touching Controls > Safety > Dashcam > Manual or Auto on your Tesla Dashboard.
- In your Tesla dashboard: Go to Controls > Charging > Keep Accessory Power On or enable Sentry mode, in order to power the VX360 properly.
- Wait a few minutes before driving after plugging the device to ensure your VX360 is fully connected.
- Check the connectivity widget on your Home screen - if it’s Active (green dot), you’re all set to start driving and earning!
Congratulations! You are now ready to begin your journey with VX360 and earn rewards!
Important:
Your VX360 must be powered to upload footage after you finish your drive. If you leave it in your car, ensure that either “Keep Accessory Power On” is enabled or Sentry Mode is active to keep the device powered.
If you see this error message on your Tesla screen :"Re-insert USB into glovebox for higher speed" there’s no need to worry. This is a default system message from Tesla. Your VX360 device will continue to function normally even if this message appears.
Comments
0 comments
Article is closed for comments.